$9.99 SHIPPING OR FREE SHIPPING ON ORDERS OVER $99 *Exclusions Apply
Low-temp hot melt for carbon shafts, instant full strength set-up in cold water. Super strong, easy to apply heat reversible. Stick will do approximately 144 inserts.
Bohning Ferr-L-Tite Melt Stick softens under flame. Good for inserting aluminum broadhead adapters and target points, reheating will allow point to be removed.
Bohning Glue Bottle Dispenser w/Tip is a clear bottle with applicator tip designed to hold 2 oz of solvent or adhesive. Comes with red cap for air tight seal.
Speeds up the drying time on all cyanoacrylate glues. Allows glues to set in only 6-8 seconds.
Fletch Fuse is designed for use with vanes, feathers and nocks. It has a clamp time of 30 seconds and a cure time of 2 minutes. Comes in a 1/2 oz. bottle.
Instant bond arrow adhesive bonds in seconds to feathers, vanes, nocks, and inserts. Apply small amount to one clean surface, then place in position desired.
Glue bottle replacement tips. 2 pk.
IC-GEL is a cyanoacrylate paste that is extremely thick which comes in an applicator tube like toothpaste. It has the same bonding and curing time characteristics as MAXI-CURE.
The ultimate high strength, impact resistant arrow insert adhesive. Specially designed for all arrow materials including carbon, aluminum and wood.
Fast set glue that does not get brittle and remains clear. For use in installation of points and inserts.
Bottle holds any standard glue while tip drops a bead of glue, used for fletching arrows.
Quick bonding agent bonds to variety of substrates with 3200 PSI strength, works great on vanes and feathers.
Debonder is used to remove old glue from arrows. Work into the glued area with a paper towel until it starts to debond the glue, and then wipe the shaft clean. Wash your hands after using this product.
Use Zing Kling to secure the vane with a strong hold on the arrow shaft. Zing Kling is thick enough to resist running and rubber-toughened to withstand abuse at high speeds. Surfaces should be clean and dry before boding. Apply enough to leave a thin...
Formulated to apply with ease and provide a superior, impact-resistant bond. Works on carbon, aluminum and wood shafts. Instantly bonds nocks, vanes, feathers and inserts.
Smooth flowing, clean stopping formula
Use for fletching, inserts, nocks &...
Black high-viscosity rubber toughened, great for carbon and aluminum shafts. Shock resistant .008" gap filler and 3700 PSI strength, military grade, max 90 second bond time temp rated 65 degrees F to +280 degrees F.
Heat reversible adhesive welds inserts and outserts to all shaft types. Increased impact resistance and increased holding power and easier to apply.
Spray-on accelerator that helps in fletching hard-to-fletch shafts. Helps on wooden arrows for fletching and point installation.
The LCA Fletching Glue is perfect for all types of fletching. Great for gluing vanes, feathers, points, inserts or bushings. The LCA glue dries fast, but dries soft, for a stronger hold and doesn't leave a white residue on your shaft after the glue dries.
Nuclear Vane Juice features a proprietary formula that strops vane quills of all oils and impurities to help create a powerful bond between the vane and shaft. Use the precision-point pen to apply directly to the quill.
Insert glue with rubber additive to allow glue joint to absorb more shock.
Nock and vane glue with a special formula for AAE Plastifletch Max and Max Hunter vanes. Will also work on most other type vanes.
© 2023 Kinsey's Outdoors
All rights reserved.